Plastic Made of Vanillin

Plastic Made of Vanillin

Author: Angewandte Chemie International Edition

From inexpensive mass products to tailored high-tech materials, our modern world is unimaginable without plastics. The major downside to this is the use of fossil fuels and the growing quantities of waste. A new approach could be the production of high-grade plastics made from biomass that could be made to fall apart into recyclable components. The “destruct command” would be given with light of a specific wavelength, as demonstrated by Mukund. P. Sibi, Dean C. Webster, North Dakota State University, Fargo, USA, Jayaraman Sivaguru, Bowling Green State University, OH, USA, and colleagues.


Biomass-Derived Polymers

Biomass is a renewable, often downright cheap raw material that is increasingly of interest for the production of high-performance plastics. However, bio-based plastics also suffer the problem of unsatisfactory recycling. Plastics have to remain reliably stable while they are in use, without the risk of premature deterioration. Recycling should also ideally be upcycling instead of downcycling. The building blocks produced should be convertible to another high-quality material. Ideally, these would be monomers that can subsequently be polymerized again to produce equally high-performance plastics.

To meet this challenge, the team chose bio-based plastics for which degradation can be triggered by irradiation with light. They were able to develop crosslinked polymers that contain building blocks in their backbone based on vanillin. Vanillin can be produced from materials such as lignin, which is a byproduct of cellulose production.


Upcycling with Light

The vanillin derivative developed by the team absorbs light at 300 nm and enters into an excited state. This leads to a chemical reaction that triggers the degradation of the polymer. Because this wavelength is not contained in the spectrum of sunlight that reaches the earth, unplanned degradation is avoided. The researchers were able to recover 60 % of the monomers, which could be polymerized again with no loss of quality.

Photodegradable, recyclable, and renewable crosslinked polymers made of biomass resources are a highly promising approach for producing more sustainable plastics. Light-triggered degradation is environmentally friendly and offers the advantage of spatial and temporal control.


Leave a Reply

Kindly review our community guidelines before leaving a comment.

Your email address will not be published. Required fields are marked *